1. the Air abrasion master use aluminum Oxide powder, For
porcelain, resin, fiber posts and brackets etc. including the metal
surface uniform micro roughening treatment, to improve the adhesive
2. the Air abrasion master made of high quality stainless steel and
special wear-resistant metal materials, durable, design ergonomic,
assembly tolerance accuracy, can effectively improve the service
life of the product and precision.
1. Extraoral application: used for cleaning and coarsening of the
surface before bonding.
Metal / porcelain crown;
Inlay / high inlay;
Orthodontic brackets and stents;
The removal of the original cement adhesive layer two times before
Defect detection of metal casting repair body.
2. intraoral applications: surface microcoarsening in the treatment
of porcelain or resin restorations.
The Air abrasion master by direct supply of dental unit, turn off
the water of dental unit before Use, will be connected with the
handpiece tube connector.
(as with a transparent hose supply pipe, if not required, can be
disassembled, the metal supply connector into the Air abrasion
master the tail of the handle can be tightened.)
1. in the course of use, the operator must wear a mask and a
goggle, and the patient must wear a goggle.
2. pressure air straight to the gums and exposed dental pulp
sandblasting will lead to bubble embolism, so when applied to the
mouth, it is recommended to use a rubber dam and a strong suction
3. if the Air abrasion master accidentally dropped again, should be
checked bottle and nozzle before use, if damaged, should be
replaced immediately, when stop use must disconnect air;
4. the Air abrasion master recommended 30-90 m high purity alumina
sand powder, and no caking damp;
5. alumina powder injection powder should not be higher than the
maximum range defined by the bottle. When the capacity is lower
than the 1/3 bottle, the air supply should be closed immediately
and the sand powder should be filled in time.
In the case of blockage:
1. blocked nozzles in a few seconds
The nozzle can be dredging clean.
2. Move the sand bottle, USE 15 # wire respectively dredging nozzle
and sand hole and the air inlet, then screw on the sand bottle, the
air pressure to the maximum (6.0kgf/cm -), using compressed air to
3. if all of the above methods can not be solved, please contact
the local distributors or send them back to the factory