Double Glazing Equipment Stainless Steel LQ2500 Vertical Glass
washing and drying machine
The machine has glass feed section, glass washing and drying
section, light inspection section.
2. The first section is equipped with LOW-E glass check system.
When the coated side is wrongly put, the system will give alarm and
the convey will stop automatically.
3.Three pairs of brushes driven separately by 3 motors. Brushes
thread are imported soft material, special for LOW-E glass.
4. Washing section uses SKF brand oil-free and water-proof
bearings. It will not cause second contamination to glass.
5. Static electricity remove device is equipped at the end of
washing section. It can remove the static electricity of the glass
so the dust will not fall on the glass.
6. Washing speed is controlled by an inverter.
Secotion1: Feed Section:
The back board is high density board with film
It is the first section of the line and its main function is to
transmit the glass to the washing and drying section. The
transmission is carried out by chains driven by the motor and the
transmission speed is stable. It runs at the same speed of the
washing and drying section and the speed can be changed by the
inverter. It can avoid the back board bending and deformation, also
can waterproof, avoid acid-base.
LOW-E glass automatic diagnosis system: it can easily know whether low-E glass putting is right or not.
When is wrong, the alarm will raise the alarm, and worker can
change it immediately. This system prevents the membrane of coating
glass (especially the LOW-E glass) from being destroyed, the glass
input conveyor station is loaded with the coating glass automatic
diagnosis system, fully guaranteed the correct washing and covering
of the coating glass.
Section2:Washing and Drying Section:
This part has three pairs of brushes (the material is high
-temperature nylon wire ) and a pair of sponge roller. The brushes
are driven by three synchronous motors separately and the movement
is stable. Three pairs of tubular rollers type of hair brushes, use
High Temperature Resistant and soft nature hair brush, fully
guaranteed the coating glass especially the LOW-E glass layer
stratification can’t be destroyed.
1. It adopts custom-made and imported nylon, front is three pairs
of soft brushes (Φ0.07mm), back is three pairs of hard brushes
(φ0.10mm),it last the brushes life.
2. According to the glass thickness, automatically control the
spacing of the drag roller, it doesn’t need any other manual
adjustment for the glass that have different thickness in the
adjustable scope by bearings.
Drying part: the air enters into the air knife from the top. The distance
between the air knife and the glass should be adjusted according to
the thickness of the glass in order to guarantee the drying effect.
Air passage adopts the most advanced design and increase the drying
speed and productivity.
1. There is a pair of rhombic air knife, the front air knife can
adjust backward or forward according the glass thickness. The
blower, which is equipped with heater, blows strong hot wind; also
it is equipped with infrared heater that can dry the both sides of
the glass quickly.
2. The dry section uses the high quality stainless steel, all of
them are anti-corrosive material (including air knife, transfer
Section3: Transition and Unloading Section:
This section is used to transmit and store the glass to improve the
work efficiency Light inspection is equipped with a foot switch.
You can stop the convey and check the washing quality.
|Power supply:||380V 50Hz|
|Max. process glass height||2500*3000mm|
|Min. process dimension:||300x400mm|
|Thickness of glass sheet:||3~15mm|
|Max. process speed:||45m/min|
Packaging & Shipping
Installation: If the buyer needs, the seller will send one or two technicians
(one is electrical engineer, one is mechanical engineer) to install
the machines and help train the workers.
Warranty time: Usually one year. It is negotiable.