WHG series turning plate dryer is turning plate with two-way
transmission principle, using hot air furnace heating or drying
flue gas as the drying medium. That improve equipment utilization of space, but also improve
ventilation and drying conditions.
Turn the main pretext plate dryer rack, tail rack, the middle
frame, traction chain, flap, rails, automatic tensioning device,
automatic heating equipment parts. The machine pressed into briquettes with a lot of water from the
dryer into the dryer upper tail flap by flap to the smooth
operation of the dryer head, along the chute into the lower deck,
and then sent back to the tail, so back and forth, briquette baking in the hot air, the gradual drying, sent by the
1, equipped with automatic tensioning device, the smooth running
chain plate, turn freely, so as to solve the swap chain, the card
chain, deviation and so on.
2, use heat-resistant steel sieve washed into a mesh, high
strength, not easy to deformation, permeability.
3 speed motor drive from the chain plate can be adjusted according
to speed, the control of drying time
4, the kiln temperature of each body figures, easy to master and
control the kiln temperature.
5, left sides of the kiln body flap machine maintenance access,
ease of maintenance of equipment.
6, the only hot air furnace heating furnace with chain automatic
heating equipment, automatic coal, automatic slag, high thermal
efficiency, coal to adapt to wide, clean environment, saving time
Seven, with fire protection devices, Kiln, kiln, kiln, with three
thermocouples, with smoke stack inlet gate, once the mechanical
failure, and immediately lay down their gates, cut off the heat
source to prevent fire.
8, quoted by negative pressure air, less dust, hot air
distribution, air inlet and the chimney with the bottom ash pond
Shen, dust emissions compliance, with spiral flap two automatic ash
removal device, easy and convenient. Pressure blast, dusty and polluting production site, and the fabric
duct prone to clogging.
9, the design goal from the tail low temperature, low temperature
of the ball, briquettes heated by a low temperature gradient, the
high temperature gradient heat, avoid moisture after molding the
briquettes containing 8-10% heat generated by a sharp