When you switch on alternating current, if the indicator light
charge isn t on the possible causes can be: (1)Power connector isn
t plugged into alternating current socket. Measures: put the
connector firmly into the power socket. (2)Alternating current
socket loosens or broke down. Measures:change a new alternating
When you press the remote control buttons, if the indicator light
on the remote control isn t on: the possible causes can be: (1)The
12 V battery stored inside the remote control has been used up
Measure: change a new battery. When you are trying to arm , within
the one-minute delay time, let the wireless magnetic switch
transmit signals .
If the user mainframe doesn t send out the message receiving clue
like BBBBthe possible causes can be: (1)The 9v battery stored
inside the wireless magnetic switch has been used up. Measures:
change a new battery. (2)The user mainframe isn t mounted with the
receiving antenna or the receiving antenna hasn t been pulled out
to the end.
Measure: store antenna and pull pole until the complete position B1
B2 B3 B4 and B 5 indicator lights are long-term on without going
out. the possible causes can be(1)The lines connection of the
detector is improper or is not well connected. Measures: check if
the nails in the end of the detector are tightly fastened and if
there is something wrong with the positive and negative ends of the
power and the end of the signal line, and correct them in time.
(2)The arming zones which doesn t mount detectors hasn t connected
the negative pole end with signal end well. Measures: use a 2.2k
resistance to tightly fastened the negative end and the signal end.
The indicator light connecting to the emergency button or foot
switch is long-term on without going out, or sometimes on and
the possible causes can be(1)The corresponding emergency button or
foot switch didn t reset. Measures:Use key to reset emergency
button or foot switch (2)The circuit of corresponding emergency
button or foot switch keeps in touch badly. Measures: Check the
circuit and connect it, tighten it and wrap it up.
When you are about to make a call and take the receiver, if the
user mainframe sounds like continuing Di Di-- , or the local alarm
gives out alerting sounds: the possible causes can beThe reason is
that your telephone is connected to the line port. And the user
mainframe has been preconditioned as line port is broken detected,
or shorts out detected, or adds the alarm function in parallel.
Measur: (1)Firstly, move the three-feet-changed socket that is on
the printed circuit board of user mainframe to the OFF position.
(2)Secondly, change to connect the telephone to the user phone T1
and T2 interface.