carbon steel allowable stress

Brand Name:ST

Model Number:Blind Flange 020

Place of Origin:China

...Carbon Steel Blind Flange 　　Contrary to all the flange types seen above, blind flanges do not have a center hole, and are used to blind or seal a pipeline, a valve/pressure vessel and block the flow of the fluid. 　　Blind flanges have to withstand remarkable mechanical stress due to the system pressure and the required bolting forces. 　　Blind flanges allow...

Country/Region:china

...carbon steel plateis a high-strength fine-grained steel used for dynamic loading of welded structures. Compared with S235J2, it has advantages in size due to its higher yield strength of 120mpa. Compared with S235J2, the anti-skid performance of S355J2 carbon steel plate is improved by 15%. The S355J2 carbon steel plate is not suitable for heat treatment. Allow stress relief annealing. S355J2 carbon steel...

Brand Name:TOBO

Model Number:WPL3

Place of Origin:CHINA

...Steel Pipe And Fittings The yield point of a steel structure determines the stress that the structure can withstand without permanent deformation. The minimum yield point of a typical carbon structural steel is 235MPa. The minimum yield point of typical low alloy high strength steel is 345MPa. Therefore, according to the ratio of its yield points, the allowable service stress...

Brand Name:FEVER

Model Number:HSS

Place of Origin:Zibo

...Steel Roll And Ring For Industral Properties The shell is a high carbon alloy steel containing Cr, Mo, W, V and Nb. The microstructure consists of complex carbides embedded in a tempered martensitic matrix. Control of the carbon and a complex heat treatment allows the optimization of wear-resistance, thermal fatigue resistance and oxide film formation, whilst maintaining low residual stress...

Brand Name:ShengDuan

Model Number:OEM/ODM

Place of Origin:Maanshan，China

... P: ≤0.035 Chromium Cr: 16.00～18.00 Nickel Ni: Allowed to contain ≤0.60 Mechanical properties: Hardness: Annealed, ≤269HB; Quenching and tempering, ≥58HRC Mechanical behavior: Internal stress (250 N/mm2) Tensile strength (560 N/mm2) EL(18%

Brand Name:FIDAK

Model Number:NIL

Place of Origin:Jiangsu, China

constant support hanger Detailed introduction Constant force spring hanger (hereinafter referred to as the constant crane) is designed according to the principle of torque balance.The load torque and spring torque are always in balance with the allowable ...

Brand Name:TOBO

Model Number:Low Alloy Steel

Place of Origin:China

... the weight. It must be noted that the allowable stresses of members that may bend must be corrected to ensure structural robustness. Sometimes carbon structural steel is replaced by low alloy high strength steel without changing the sectional size, the